Genuine Honda Acura Gray Lip Spoiler Rubber Molding Strip with 3M Tape

Genuine Honda Acura Gray Lip Spoiler Rubber Molding Strip

Finish your front lip, rear lip, spoiler, or underbody accessory with this genuine Honda and Acura gray rubber molding strip. Designed to create a cleaner transition between an accessory and the painted body surface, the molding can also help reduce direct contact between the installed component and the vehicle’s paint.

The gray finish is well suited for lighter-colored vehicles and projects where a softer contrast is preferred over black molding.

Product Details

• Genuine Honda and Acura accessory molding
• Gray rubber trim strip
• Honda/Acura part number: 08F03-SHJ-1200D
• Pre-applied self-adhesive trim tape
• Includes 3M Automotive Adhesion Promoter 06396
• Suitable for front lips, rear lips, spoilers, and underbody accessories
• One kit covers one lip or one spoiler
• Can be trimmed to suit the installation

Intended Applications

This molding strip may be used as a finishing edge between an accessory and the painted body surface on compatible Honda and Acura applications.

Common uses include:

• Front lip spoilers
• Rear lip spoilers
• Trunk or decklid spoilers
• Side or underbody accessories
• Custom body-kit installations
• Replacement of worn or missing accessory molding

This is not a vehicle-specific structural component. Confirm the required length, shape, and installation method before ordering.

Clean Finished Appearance

The flexible rubber molding helps create a more finished appearance where a lip spoiler or accessory meets the body panel. It may also help minimize direct rubbing between the accessory and the painted surface when installed correctly.

Adhesive Installation

The strip includes self-adhesive trim tape for installation. The supplied 3M adhesion promoter helps prepare the mounting surface and improve tape adhesion.

For best results:

1. Clean the installation area thoroughly.
2. Remove wax, oil, dirt, and adhesive residue.
3. Test-fit and measure the molding before removing the backing.
4. Apply the adhesion promoter according to its instructions.
5. Press the molding firmly into position.
6. Allow adequate bonding time before driving or washing the vehicle.

Installation results depend on surface preparation, temperature, accessory shape, and mounting condition.

Important Notes

• One kit covers one front lip, rear lip, or spoiler.
• Measure the intended installation area before ordering.
• Some trimming may be required.
• Verify compatibility with the accessory being installed.
• Professional installation is recommended when fitting body accessories or spoilers.